Image Update & H8 Firmware Update
In these times of dynamic changes technical solutions need to be developed on a regular basis. New technologies and changes regarding required components require to adapt the hardware of existing solutions and therefore result in various product versions.
As a matter of course, for each product version the appropriate firmware is available for download.
To ensure that you install the suitable firmware for your module it is absolutely necessary to answer a few questions in advance to determine the hardware version you are currently using.
Before determing the hardware version for the Module 8029NTS/M please note the following information regarding the update:
- Only experienced users or trained technical staff should carry out a firmware update after checking all necessary preconditions.
- Important: an incorrect update or an incorrect update trial may require to send the module to hopf Elektronik GmbH for a fee-based repair.
- Is the update version which is available suitable for your module? In case of uncertainty please contact the support team of hopf Elektronik GmbH.
- Under no circumstances do not carry out a downgrade!
- To ensure a correct update you need to adjust the function "new version of saved site" to "each time the website is accessed" in the used internet browser.
- During the update process the module must not be switched off nor the settings may be saved on flash!
- Updates always need to be implemented as software set. That means that all programs contained in the set must be installed. Further information which program versions belong to which set can be found in the release notes!
- The present firmware can ONLY be used for LAN module 8029NTS/M (NOT for basic clock systems 8029HEPTA/GPS, 8029NTS/GPS respectively 8029NTS/DCF)!