Newsletter · Contact · Deutsch

Because every fraction of a second counts 

FO-StarCoupler 4810

Short Description

The hopf FO-StarCoupler for 35mm DIN rail mounting (DIN EN 50 022) is a low cost solution for the active distribution of a FO-signal to up to 7 FO-outputs.

All FO-components of the FO-StarCoupler are of ST (bayonet) type and designed for multi-mode cables. Each component of the FO-StarCoupler has its own status LED.

 

In order to facilitate its use on a worldwide scale, the power supply to the FO-StarCoupler has a wide input range.

In this way the device can be installed in any place in the world without failing when the input voltage range changes.

Features

Currently two versions of the hopf FO-StarCoupler are available.

FO-StarCoupler (1-IN/4-OUT)

StarCoupler 4810 with 1x in and 4x out
  • Nominal input voltage 100 - 240V AC via 3-pole screw terminal (plug-in)
  • FO-components:
    • 1 FO-Receiver (820 nm, ST type, bayonet plug, multi-mode)
    • 4 FO-Transmitters (820 nm, ST type, bayonet plug, multi-mode)
  • Each output signal individually invertible
  • 6 status LEDs for:
    • Power supply unit
    • FO-Receiver
    • Each FO-Transmitter
  • Robust aluminium housing:
    • 100 x 105 x 175 mm (W x H x D)
    • For rail mounting / for 35 mm DIN rails per DIN EN 50 022
    • IP40 Protection Class

FO-StarCoupler (1-IN/7-OUT)

StarCoupler 4810 with 1x in and 7x out
  • Nominal input voltage 100 - 240V AC via 3-pole screw terminal (plug-in)
  • FO-components:
    • 1 FO-Receiver (820 nm, ST type, bayonet plug, multi-mode)
    • 7 FO-Transmitters (820 nm, ST type, bayonet plug, multi-mode)
  • Each output signal individually invertible
  • 9 status LEDs for:
    • Power supply unit
    • FO-Receiver
    • Each FO-Transmitter
  • Robust aluminium housing:
    • 100 x 105 x 175 mm (W x H x D)
    • For rail mounting / for 35 mm DIN rails per DIN EN 50 022
    • IP40 Protection Class

Downloads

PDF documents

Software and Driver

  • For this product there is no Software / Driver available.